Flexible connector 2301 descends from capstan shaft 2303 and passes through aperture 2302 where it connects to float 2310, and thereafter (perhaps indirectly through float 2310) to inertial mass 2315. After passing over and on to shaft 2303 of the capstan, flexible connector 2301 is wound 2319 and 2318 over the two capstan shafts (in a spiraling fashion) approximately nine times, after which the other end of the flexible connector descends from capstan shaft 2304 and passes through aperture 2320 where it connects to restoring weight 2309. Rotating capstan shafts 2303 and 2304 each have a series of raised ridges forming inset sheaves in which segments of connector 2301 can run.
First, in this embodiment, restoring weight 5-160 is connected by connector linkage 5-158 to depending connector segment 5-150a. Connector linkage 5-158 connects to depending connector segment 5-150a at connection point 5-159. The addition of connector linkage 5-158 thus creates a “closed loop” consisting in part of depending connector 5-150 and in part of connector linkage 5-158. This “closed loop” enables the device to passively enter an “inactive mode” as displayed in FIG. The distance between restoring weight 1-160 and the flotation module 1-105 can decrease, while the distance between the inertial mass 1-140 and the flotation module 1-105 can increase. A sensor for an indicator of inertial mass depth 22-1010 records, receives, or senses a physical characteristic and/or signal relevant to the computation of an indicator, predictor, measure, estimate, correlate, and/or statistic of the depth in the body of water of the inertial mass, and/or an indicator, predictor, measure, estimate, correlate, and/or statistic of the vertical separation distance between the inertial mass and the flotation module.
Tipos De Dolor Dental
The number of offset weights that contributes to the effective net weight of its inertial mass is directly correlated with the average depth of that inertial mass. Cable 555 is wound around roller 552 in the opposite direction that characterizes the winding of ribbon cable 553/559 around the roller. This mass of seawater is substantially “trapped” by, within, and/or against the inertial mass (e.g., by, within, and/or against its substantially impermeable walls) when the inertial mass is accelerated in a relevant direction. In some embodiments, this helps achieve the directional rectification of the flotation module, or in other words to ensure that when the flexible connector is under tension, the bottom of the flotation module points approximately in the direction of the inertial mass (i.e. Fourth, generator housing 4-120 contains a flywheel that can store kinetic energy. Through the appropriate regulation and/or control of the amount of torque imparted to the traction winches by their respective PTOs, the amount of upward kinetic and gravitational potential energy imparted to the inertial mass by the buoy, can be controlled and/or regulated.
The flotation module has an approximately flat upper surface 320, a flat lower surface 334, and an approximately rectangular lateral shape with approximately straight vertical sides 322 that are beveled 334 at their lower extents. As generator 153 generates electrical power, it also exerts an inhibiting or resistive torque on pulley 152 that resists the pull of inertial mass 159 on connector 155. This relatively upward force imparted to inertial mass 159 by pulley 152 through flexible connector 155 provides an upward acceleration to the inertial mass. Tratamiento para dolor de rodilla izquierda . As the buoy is moved up and down by waves, the inertial mass 105 resists that motion, thereby causing the ribbon cable 104 to move over, around, and/or relative to, the gears, pulleys, drums, and/or cable-engagement components, of the PTO 102, thereby generating electrical power. When the distance between the submerged inertial mass and the illustrated buoy 770 is decreasing, the generator 795 can be used as a motor, run in reverse, and thereby remove any slack that might develop in the flexible connectors.
Dolores Musculares Covid19
Owing to the inertial mass’s resistance to rising, the distance between the flotation module and the inertial mass can increase as the flotation module rises. The force imparted to the inertial mass 1313 at point 1305 by cable 1307 is directed along the dashed line descending from point 1305. This force is applied to inertial mass at an approximate distance of 1311 from its center of gravity 1314. This off-center force imparts to inertial mass 1313 a torque 1312 which will tend to impart a rotation to the inertial mass, thereby reducing its stability. The further the at least one pulley/capstan is located from the center of rotation of the flotation module, the greater will be the torque imparted to the flotation module with respect to its center of rotation, and the more effective the aligning moment will be. In this way, the movements of the inertial mass will typically be reciprocal but out of phase with the movements of the flotation module.
FIG. 129 illustrates a potential disadvantage of connecting a buoy to a submerged inertial mass by a pair of laterally separated vertical cables. Eight cables, e.g. 133 connect the buoy to the submerged inertial mass (132 in FIG. 2804, one of which passes through each orifice, e.g. The connector 199 passes up from the depths of the body of water, through a central aperture 197, to a generator or other power take-off (PTO) assembly 192, and it 200 then passes back through the aperture 197 and back in to the depths below where the distal end is connected to a restoring weight.
Dolores Musculares Piernas
In some cases, these are one and the same flexible connector; in other cases, the flexible connector passing to the inertial mass is distinct from the flexible connector passing to the restoring weight. 170, wherein a restoring weight 413 “hangs” below, and pulls from below, on a pulley 412 operatively connected to a flexible connector 409-411, the restoring weight 3014 is supported by, and pushes down upon, a pulley 3018 operatively connected to a flexible connector 3015 and 3017. The restoring weights in the embodiments illustrated in FIGS. In particular, in some embodiments, a time-averaged absolute value of the drag force acting on the inertial mass over a given period of time can be compared to a time-averaged absolute value of the tension in the flexible connector over the same period of time, and the latter is far greater than the former (e.g.
Dolor Neuropático Crónico
Voids, e.g. 212, inside the flotation module are oriented such that their longitudinal axes are approximately vertical. Dolor de rodilla y codos . At least one connector of each pair of flexible connectors is connected to a submerged object that is used to generate tension in the respective connector in response to the passing of waves at the surface 2301 of the body of water. 700 and positioned above a pair of adjacent apertures 702 and 710. One end of a multistranded ribbon cable 797 is connected to an anchoring screw embedded in the seafloor (not visible) located below the buoy. 326, positioned at the corners between the module’s sides. 180 are positioned outside flotation module 1401, and are protected within a housing, lid, shroud, canister, and/or pod 1402 attached, e.g. In some embodiments, the fluid within the computing chamber 106 is air.
Dolores Musculares Generalizados
In some embodiments, the top-view cross section of the inertial mass can be other than a circle. Such a solid inertial mass might be composed of a mixture of (typically positively buoyant) recycled plastics and (typically negatively-buoyant) recycled metals. Lateral post-tensioning cables span the entire width and/or breadth of the flotation module, and are attached and/or anchored to force-distribution plates, e.g. When active, the ducted fans consume a portion of the electrical power generated by the generator 215. Through the controlled variation of, and/or the creation of a differential, thrust generated by the fans, the buoy, may propel itself in any direction, and/or to any specific location (e.g. The present disclosure includes embodiments with rollers characterized by any circumferential surface configuration, shape, attribute, and/or quality. The inertial mass can be constructed inexpensively as a submerged, substantially hollow vessel, container, or enclosure having rigid and/or flexible walls.
138, and through its respective hollow connecting arm, e.g. Dolor en el muslo derecho de la pierna . 138, are able to rotate about the axes of rotation of their respective hollow connecting arms, e.g. Each roller, e.g. 38, is rotatably connected to a ribbon cable, e.g. The other end of each driving rod is rotatably or hingably connected to one end of a “connecting rod,” e.g. 169 dangling end 654. In other embodiments, no change in gauge is used. In order to achieve these ratios, several design features have had to be invented and/or combined in novel ways in our preferred embodiments, including but not limited to the “ribbon-like” flexible connector described below (i.e. The power cable in this embodiment is suspended by floats e.g., 7-755. In other embodiments, the power cable is spliced into a subsea power cable near the seafloor. A buoy 210 floats adjacent to an upper surface of a body of water.
A buoy 415 floats adjacent to a surface of a body of water. The inertial mass 419 is open on its bottom 422 to the surrounding water 400. It is closed on all other sides, e.g. 133, may result in the level of the water around the buoy, i.e. The directional rectifying pulley herein disclosed avoids the cable damage and wear frequently attributed to “excessive fleet angle,” i.e. 198 has two independent inertial masses, each of which applies a separate and independent inertia damping force to flotation module 2501. Each inertial mass, e.g. In its nominal configuration, e.g.
- Sirve la infusión con una rodaja de limón
- Dolor muscular
- Determinar si un tumor es benigno o canceroso
- Indicará reposo en la cama a fin de reducir el riesgo de aborto
- Equipment according to claim 6 also comprises
- Abdominales bajos
- Tómalo máximo dos veces al día, ya que en exceso puede ser perjudicial
- Disfunción de la trompa de Eustaquio (especialmente de los más pequeños),
As a wave recedes, and flotation module 2300 moves downward, inertial mass 2315 is able to fall under its own net weight, although there may be a delay in its assuming a downward momentum due to its relatively large mass and hence relatively large upward inertia. Inertial mass 3027 is a constricted channel (e.g.